Roomaid: Filter Changes

Please read and follow the directions below to replace any filter(s) on your Roomaid HEPA Air Filtration System.

To view an animation of a complete filter change including the new heavy duty VOC Canister, select video link below. You will have to download the file first to run the animation.

Low-Res Animation (320 x 240 - 1MB)

Hi-Res Animation (640 x 480 - 2.75MB)


Pre-filter Replacement 1. Turn the unit off and unplug it. 2. Remove the used pre-filter and carefully discard it in a plastic bag. 3. Line up the seam in the pre-filter with the receptacle at the back of the unit. Pull the new pre-filter over the unit so it snugly covers the screen. 4. Plug the unit in and turn it on.

	VOC Filter Replacement 1. Turn the unit off and unplug it. 2. Turn the unit upside down. With one hand holding the HEPA Cartridge, pull the motor/fan housing off. 3. Remove the used VOC Filter (carbon blanket) and carefully discard it in a plastic bag. 4. Roll the new VOC Filter into a cylinder smaller than the size of the opening in the HEPA Cartridge. Insert the VOC Filter all the way into the well and spread it open against the HEPA filter. 5. Sit the motor/fan housing right side up and seat the gasket in the groove. 6. Place the HEPA Cartridge on the motor/fan housing and align the plugs in the cartridge with the holes in the housing. Once the holes are aligned press firmly on the top of the cartridge to secure it to the housing. 7. Plug the unit in and turn it on.

HEPA Cartridge Replacement 1. Turn the unit off and unplug it. 2. Turn the unit upside down. With one hand holding the HEPA Cartridge, pull the motor/fan housing away. Discard the cartridge in a plastic bag. 3. Sit the motor/fan housing right side up and seat the gasket in the groove. 4. Place the HEPA Cartridge on the motor/fan housing and align the plugs in the cartridge with the holes in the housing. Once the holes are aligned press firmly on the top of the cartridge to secure it to the housing. 6. Plug the unit in and turn it on.